List of All Products

Power Reactor
Power Reactor pg1 co2

The fluidized gas bed is up to 100 times more efficient than passive reactors. Ideal for cylinder or yeast generated CO2. Serves any sized tank up to 200 gallons+ Super easy set up, no connection needed to existing filters, just attach the CO line and plug it in. Maintenance and cleaning is a snap without connections to existing filters. Smooth, even 2 dia. discharge flow keeps more CO2 in suspension for longer. Night Spikes are easily controlled using an inexpensive plug in timer. Rugged heavy duty construction, Chamber guaranteed 1 year against defects in material and workmanship, Pump guaranteed for six months by Rio.


		SETUP


	REMOVE THE RIGID CO2 SUPPLY TUBE FROM THE CHAMBER AND ATTACH YOUR CO2 SUPPLY LINE TO IT. ATTACH THE PUMP TO THE CHAMBER. NIPPLE BY GENTLY PUSHING THE PUMP DOWN OVER THE NIPPLE WITH SLIGHT TWISTING BACK AND FORTH MOTION. THIS IS A FRICTION FIT SO THAT THE HEAD CAN BE EASILY PUT ON AND TAKEN OFF FOR MAINTENANCE.


	ATTACH THE CHAMBER WITH PUMP ANYWHERE IN THE TANK SO LONG AS YOU HAVE AT LEAST 1/2” OF WATER ABOVE THE TOP AND BELOW THE BOTTOM OF THE PUMP. INSERT THE CO2 SUPPLY LINE BACK INTO THE CHAMBER. PLUG IN THE PUMP THAT’S ALL THERE IS TO IT!!!

		MAINTENANCE


	REMOVE THE RIGID CO2 SUPPLY TUBE USING A GENTLE BACK AND FORTH TWISTING MOTION LOOSEN THE PUMPHEAD FROM THE CHAMBER AND ALLOW IT TO DANGLE IN THE TANK. THERE’S NO NEED TO REMOVE IT FROM THE TANK. RELEASE THE SUCTION CUPS BY SLIPPING A FINGERNAIL UNDER THE LIP OF EACH CUP AND GENTLY LIFTING.



	CLEAN ANY DEPOSITS IN THE CO2 SUPPLY TUBE WITH A PIPE CLEANER OR TOOTH PICK.



		REMOVE THE “STAY ROD” HOLDING THE BUBBLE PAD IN PLACE AND REMOVE THE PAD CLEAN THE CHAMBER WITH A BOTTLE BRUSH



RUN WATER THROUGH THE BUBBLE PAD. LOOSEN ANY STUBBORN DETRITUS BY SLAPPING THE PAD AGAINST THE SIDE OF THE SINK THEN RE-RINSING.


	REINSTALL THE BUBBLE PAD SYMMETRICALLY INTO THE CHAMBER. THIS IS DONE BY CENTERING THE PAD OVER THE CHAMBER OPENING, WITH THE THUMB OR FOREFINGER PUSH THE CENTER OF THE PAD INTO THE CHAMBER WHILE GUIDING THE EDGES WITH THE FINGERS OF THE OTHER HAND REINSTALL THE “STAY”

Weight: 2.90